Step 1: Prep & Clean
Clean and prepare surface. Typically a clean cloth and water works great. Household cleaners are not recommended.
In general TrueUp adhesive strips will work on surfaces that are clean and flat.
- Painted walls
- Painted brick or cinder blocks
Not Recommended Surfaces
TrueUp is not recommended for:
- Heavily textured walls
- Unpainted brick
- Nonstick materials
- Varnished wood
Apply & Level
A – Apply TrueUp adhesive strip to the back of the wall mount.
B – Press firmly at six points, working from the outside in.
Mounts work best with frames 12 inches in width or shorter. If longer than 12 inches, use a second mount.
Slide level onto mount.
If you need to install an adaptor on your frame, do so before moving to the “Hang & Adjust” steps.
Installing the Frame Adaptor
Make any frame TrueUp compatible
Hold adaptor with extruding bar facing you & small ridge side down. Apply an adhesive strip to each end of the adaptor as shown above.
Press and hold each adhesive strip to the adapter at 4 points for 5 seconds each.
Peel adhesive backing.
Hold adaptor centered to the frame with small ridge facing downwards.
For best results, make sure extruding bar side is flat to the frame edge before pressing the adhesive side to the back of the frame.
Press and hold for 5 seconds each at 6 points along surface.
Hang & Adjust
Turn wall mount over and peel off remaining adhesive liner. There will be one on each side.
Grab both ends of the mount and bring close to wall, press onto wall when level.
Slide the level off of the mount and press it firmly on the wall.Slide level onto mount.
Press firmly on the mounting plate with thumbs for 5 sec from the outside working in.
For best results wait 1 hr before hanging.
When good enough becomes perfect.
Removing the TrueUp mount
Pinch both left and right adhesive strip tabs, pull outward slowly and parallel to the wall.
Take your time. The adhesive will stretch until the mount releases from the surface.
After the mount is removed, the remainder of the adhesive can be removed from the mount.
The mount can now be fitted with a new TrueUp strip and be reused.